Skip to content Skip to sidebar Skip to footer

Cat 3126 Oil Sending Unit

Cat 3126 Oil Sending Unit. I believe one is the sending unit and the other is the low pressure switch. It has wiring that plugs into the sending unit.

Cat 3126 Oil Sending Unit
Cat 3126 Oil Sending Unit from cu-cats.blogspot.com

When idling after a long haul, the pressure may go way down. I believe one is the sending unit and the other is the low pressure switch. This sending unit is connected to a pair of vdo four gauge clusters reporting oil, temp.

Can You Tell Me If This Is Due To A Technical Change In The Grounding Or Engine Electronics For The Caterpillar 3126 Engines?


When you need parts for caterpillar 3116, 3126 and 3176 series engines, diesel parts direct should be your first stop. Second oil sensor same side of engine about 6 inches in front of engine ecm looking from back to front. It is also closely associated with the cat 3116 diesel engine, which is primarily used in marine applications.

Went To Cat And They Had Trouble Locating The Sender.


April 15, 2012, 07:29:32 am ». The light goes off and the warning chime stops after a few seconds. Marine environments are demanding, and you can rest assured that we only sell top quality parts that will withstand the beating.

Ships From And Sold By Takepart.


It has wiring that plugs into the sending unit. As the oil heats up, the pressure drops. Up to 15% cash back 3126 marine:

The Last 50 Miles I Noticed It Was Fluctuating Between 30 To 40 Psi.


When idling after a long haul, the pressure may go way down. I had an oil pressure sending unit acting up(reading zero), swapped the two from engine to engine and revealed it was in fact the sending unit. I tracked down the one that cat says originally was installed on the engine but, i am wondering if someone may have replaced it over the years.

I Am Looking For An Oil Sending Unit For My Cat 3126 Marine Diesel.


Hi all, i’m running a 37 egg harbor sport yacht with 420 hp cat 3126ta’s. The pressures went back up to the average norm. My oil pressure in my 3126b cat has all ways been steady at 50 psi at normal highway driving speed.

Post a Comment for "Cat 3126 Oil Sending Unit"