Cat 3208 Injection Pump Remove And Install
Cat 3208 Injection Pump Remove And Install. Remove two nuts (2) and the tachometer drive. Rebuild service for injection pump for caterpillar 3208.
Remove two nuts (2) and the tachometer drive. Turn the crankshaft (clockwise) until the timing pin drops into the groove (slot) in the fuel injection pump camshaft. From there you will need to rotate the engine clockwise from the.
Rebuild Service For Injection Pump For Caterpillar 3208.
$600.00 / you are placing an order for a. Up to 15% cash back hello i have a cat 3208 i need the injection pump install and timing procedures. Remove two nuts (2) and the tachometer drive.
From There You Will Need To Rotate The Engine Clockwise From The.
Exhaust system not open 4. Ask your own medium and heavy trucks. Turn the crankshaft (clockwise) until the timing pin drops into the groove (slot) in the fuel injection pump camshaft.
Remove Two Nuts (2) And The Tachometer Drive.
The one on the far left is referred to as the “s” injector because it was the injector used on the “40s” serial. It is gear driven but it has nothing on its shaft to index it.it has a tapered shaft that goes into the drive cear in the front cover.you will need a few special tools one to press the. Then install the timing pin.
Back The Center (Pushing) Bolt Out, Fit Puller To Gear Using The Two 1/4 Bolts, Screw Pushing Bolt In Until Contact With Shaft, Continue Turning Pushing Bolt To Pop Gear Off Of Shaft.
Turn the crankshaft (clockwise) until the timing pin drops into the groove (slot) in the fuel injection pump camshaft. Up to 15% cash back remove the 9/16 size plug from the top of the pump. Install 854627 circuit tester (continuity light) 5tart engine.
Post a Comment for "Cat 3208 Injection Pump Remove And Install"